Lenovo ThinkSystem SD665-N V3 Manual page 91

Make sure CDU supply water temperature and flow rate per tray is within operating specifications.
• FQXSPPU0002G: The Processor [ProcessorElementName] is operating in a Degraded State.
This message is for the use case when an implementation has detected a Processor is running in the
Degraded state.
Severity: Warning
Serviceable: Yes
Automatically notify Support: No
Alert Category: Warning - CPU
SNMP Trap ID: 42
CIM Prefix: PLAT CIM ID: 0038
User Action:
Complete the following steps:
1. Check the XCC event log for any fan, cooling or power related issues.
2. Make sure power supply unit is installed correctly and clean.
3. Make sure that the water temperature and pressure drop is within the requirement of each
configuration
4. Make sure that the room temperature is in the range in the operating specifications.
5. If the problem still exist and XCC event is realted to power supply unit, please upgrade power supply
unit with supported specification.
6. Once you finish the action above and can't solve issue, please contact Lenovo support.
• FQXSPPU0003N: [ProcessorElementName] has Failed with IERR.
This message is for the use case when an implementation has detected a Processor Failed - IERR
Condition.
Severity: Error
Serviceable: Yes
Automatically notify Support: No
Alert Category: Critical - CPU
SNMP Trap ID: 40
CIM Prefix: PLAT CIM ID: 0042
User Action:
Complete the following steps:
1. Check Lenovo support site for an applicable service bulletin or UEFI firmware update that applies to
this Processor error.
2. Reboot system.
3. If problem persists, collect Service Data log.
4. Contact Lenovo Support.
• FQXSPPU0004M: [ProcessorElementName] has Failed with FRB1/BIST condition.
This message is for the use case when an implementation has detected a Processor Failed - FRB1/BIST
condition.
Severity: Error
Serviceable: Yes
Automatically notify Support: Yes
Alert Category: Critical - CPU
SNMP Trap ID: 40
.
Chapter 2 XClarity Controller events
87