Lenovo ThinkSystem SD665-N V3 Manual page 186

• FQXPMCL0005I: Start to install OS.
Severity: Info
User Action:
Information only; no action is required.
• FQXPMCL0005K: Current System Boot Mode is Legacy. OS Clone only support UEFI Mode.
Severity: Warning
User Action:
1. Change Boot mode to UEFI mode (UEFI Setup -> Boot Manager -> Boot Modes -> System Boot
Mode and select UEFI Mode.)
2. Clone the image over and retry the operation.
• FQXPMCL0006I: Export raid config successfully.
Severity: Info
User Action:
Information only; no action is required.
• FQXPMCL0006K: Failed to export raid config.
Severity: Warning
User Action:
1. Check the following Lenovo support site for information on supported RAID adapters. http://www.
lenovo.com/us/en/serverproven/index.shtml
2. Ensure RAID adapter, LXPM, and UEFI firmware are at the latest levels.
3. Ensure the state of the RAID adapter and disk drives are normal.
4. Verify proper physical connection of the disk drive, SAS expander (if applicable) and RAID adapter.
5. Reboot the machine and retry the export of the RAID configuration.
6. If the problem persists, contact technical support.
• FQXPMCL0007I: Import raid config successfully.
Severity: Info
User Action:
Information only; no action is required.
• FQXPMCL0007K: Failed to import raid config.
Severity: Warning
User Action:
1. Check the following Lenovo support site for information on supported RAID adapters. http://www.
lenovo.com/us/en/serverproven/index.shtml
2. Ensure RAID adapter, LXPM, and UEFI firmware are at the latest levels.
3. Ensure the state of RAID adapter and disk drives are healthy.
4. Ensure good physical connection between the disk drives and RAID adapter.
5. Ensure the platform and RAID config is identical to original configuration.
182
ThinkSystem SD665-N V3 Messages and Codes Reference