Lenovo ThinkSystem SD665-N V3 Manual page 163

1. Perform a virtual reseat or AC cycle the server.
2. If the problem returns Collect Service Data log.
3. Contact Lenovo Support.
• FQXSFMA0048M: DIMM [arg1] has been disabled due to PMIC failure during POST.[arg2]
Severity: Warning
User Action:
Complete the following steps:
1. Power off the system and remove A/C power.
2. Reseat the DIMM in the slot specified by the event message.
3. Restore A/C power and power on the system.
4. If the problem persists, collect Service Data logs and contact Lenovo Support.
• FQXSFMA0049M: DIMM slot [arg1] was disabled due to DDRIO power failure. DIMM [arg2] is
detected but DIMM [arg3] is not.
Severity: Warning
User Action:
Complete the following steps:
1. Power off the system and remove A/C power.
2. Please check DIMM slots specified in the message.
3. If all DIMMs detected or error persists after removing undetected DIMMs, please reseat all the
DIMMs in the slots specified by the message and then restore the A/C power and power on the
system.
4. If the problem persists or undetected DIMM needs to be replaced, collect Service Data logs and
contact Lenovo Support.
• FQXSFMA0050G: DRAM PFA threshold limit has exceeded on DIMM [arg1] Rank [arg2] sub-
Channel [arg3] DRAM [arg4].[arg5]
Severity: Warning
User Action:
Complete the following steps:
1. Power off the system and remove A/C power.
2. Reseat affected DIMM.
3. Restore A/C power and power on the system.
4. Check Lenovo support site for an applicable service bulletin or firmware update that applies to this
memory error.
5. If the problem persists, collect Service Data logs and contact Lenovo Support.
• FQXSFMA0051I: DIMM [arg1] has been disabled due to memory population rule conflict.[arg2]
Severity: Info
User Action:
Complete the following steps:
1. Power off the system and remove A/C power.
2. Make sure memory configuration is valid, see https://dcsc.lenovo.com/#/memory_configuration
. 159
Chapter 3 UEFI events