Graco A Series Instructions-Parts List Manual page 6
Power supply module , dispensing module , fluid meter
Hide thumbs
Also See for A Series:
- Instructions - parts manual (52 pages) ,
- Instructions-parts list manual (48 pages) ,
- Manual (36 pages)
Table of Contents
Advertisement
Install
and Wire
Modular
Fluid
Commander
Have a licensed electrician
wire the system according
to
local codes for Class 2 circuits and the following
instruc-
tions.
Instructions
for wiring
a basic, typical
system are
shown
in Fig 7, page 7.
Select
a location
for your Modular
Fluid Commander
where counters
and totalizers
are easily seen and con-
trols are within
reach. The control
modules
(A,B,C)
can
be wall-mounted.
Before
mounting,
connect
the
power
terminals
of
modules
and fasten
together
with
screws
provided.
Fasten the right
end panel (8) to the last dispensing
module.
See Fig 2.
Mount
the junction
strips (D) on the wall, side by side.
Each junction
strip has two holes in each end for l/4 in.
screws.
See Fig 3.
Fig 3
Label Control
Modules
and Dispensing
Stations
Label control
modules
(A,B) and dispensing
stations
(S)
using pressure
sensitive
labels provided
in the instruc-
tion manual
envelope.
Above
the counter
(GG), place
QUART
or LITER
label,
depending
upon
how
you
measure your fluids.
Label each module
below the sta-
tion selector
(HH) for the fluid it controls.
Fig 4 shows
OIL and ATF labels. Label hose reels to correspond
with
the modules
that control
fluid to each reel. Locate label
on each side of shroud
at the bottom
curved
portion.
Place dispenser
bar labels in space provided
at the top
left of bar.
-GG
C
A
B
Fig 4
Install the electric
cable, using only pre-connected
elec-
trical cable (WI.
Do not connect
to junction
strip yet.
We recommend
marking
each cable with the dispensing
module and station
positon
that it will connect
to as the
wiring
is completed.
NOTE:
Where
lengths
of cable are connected,
form
loops and secure with a wire tie (XI or tape
to avoid strain on connections.
See Fig 5.
Fig 5
Use a splice connector
(Y) to
connect
pilot "ready"
lights of dispenser
to solenoid
valves (RI. Lay the lead
wire from the light and one of the lead wires from the
solenoid
valve in the connector
and fasten the connec-
tor. Then connect
the remaining
lead wire (Z) from the
solenoid
valve
to
the
wire
that
will
connect
that
dispenser
to the corresponding
connection
on the junc-
tion strip. See Fig 6.
Fig 6
+ OUT
6
307-362
Advertisement
Table of Contents
