Adapting The Programming Station To Your Machine Tool - HEIDENHAIN TNC 415 Manual

Setup
Adapting the Programming Station to your Machine Tool
Your Programming Station has been shipped already loaded
with Standard machine Parameters settings. These settings
are sufficient to enable you to begin working with it. However,
you tan also have the Programming Station fit your specific
machine tool in regard to its axis designations, permissible
spindie Speeds, and other Parameters. This is done by
transferring the machine Parameters from your machine to the
Programming Station. You tan also store the Parameters for
several machines and activate them as needed for the graphic
test run.
l
l
l
l
l
l
Connect the free serial port on your PC with the data
interface of your machine.
If you are using the serial port COM 1:
Start the programming Station with "ppcoml/list".
If you are using the serial port COM 2:
Start the Programming Station with "ppcom2/list".
At the TNC on your machine tool, select the operating
mode PROGRAMMING AND EDITING.
At the TNC on your machine toot, use the MOD key to
select the interface mode FE 1, baud rate 38 400.
Enter the code number 95148.
Caution!
You are now in the machine Parameter list. DO not
Change any of the Parameters!
Press the EXT key on the TNC operating Panel and use the
cursor keys to address and select the soft key TRANSFER
TNC + EXT. This transfers the machine Parameters to the
PC.
Exit the EXT mode and the machine Parameter list by
pressing the END key twice.
At the Programming Station, leave the programming
Station Software with the "Esc" key on the PC keyboard
and Start it again with "ppcoml/List" or "ppcomZ/List",
depending on which PC port is connected to the LE 415 L
logic unit of the Programming Station.
Now press the MOD key on the TNC keyboard of the
Programming Station and enter the code number 95148 to
access the machine Parameter list. Then use the cursor
keys and the soft key TRANSFER EXT + TNC to transfer
the
machine Parameters.
27