Overview; Serial Number And Nameplate - SCHIEBEL AB3 Operating Instructions Manual

2 General

2.1 Overview

Figure 1: 1. . . Motor, 2. . . Connection compartment, 3. . . SMARTCON control unit, 4. . . Operating unit,
5. . . Handwheel, 6. . . Signalling lid, 7. . . Lever for manual operation

2.2 Serial number and nameplate

Each actuator and each SMARTCON control unit carries a serial number. The serial number is a 8-digit
number that begins with the year and that can be read from the nameplate (see Figure 2 and 3)
The nameplate of the actuator is located under the hand lever and the nameplate of the SMARTCON control
unit is located on the control unti (see Figure 4).
Using this serial number, SCHIEBEL can uniquely identify the actuator (type, size, design, options, technical
data and test report).
Type: AB5 E 20
No.: 1980 1266
Close: 40,0-60Nm (45,0Nm)
Open: 40,0-60Nm (45,0Nm)
40,0revs. 120sec
20,0rpm
L11-A020
Josef Benc Gasse 4, 1230 Vienna, Austria
Figure 2: nameplate of the actuator
1
Figure 4: 1. . . nameplate of the SMARTCON control unit, 2. . . nameplate of the actuator
Actuators which are suitable for operation in explosive atmosphere (see EU-Richtlinie 2014/34/EU and
EN60079-0 Standard) are separately designated by a special model plate (Ex, TÜV-Standard, see Figure
5 and 6).
6
Operating Instructions for Actuators Type AB with Control Unit
1
2
3
4
2019
IP67
190733/1
OM-ENGLISH-ABCSC.V1.2-16xx-V2.02-2023.04.27
Figure 3: nameplate of the SMARTCON control unit
5
6
7
2