Original Declaration Of Incorporation Of Partly Completed Machinery - SCHIEBEL AB3 Operating Instructions Manual

Operating Instructions for Actuators Type AB with Control Unit
OM-ENGLISH-ABCSC.V1.2-16xx-V2.02-2023.04.27
12 Original Declaration of Incorporation of Partly Completed Machin-
ery
According Machinery Directive 2006/42/EC, (Annex II, sub. B)
The maufacturer, the company:
SCHIEBEL Antriebstechnik Gesellschaft m.b.H.
hereby declares that the partly completed machinery described below:
Electric actuators series:
AB rAB
with optional additional components:
Smartcon CSC
the following basic requirements of the Machinery Directive (2006/42/EC) are applied and fulfilled:
Annex I, articles
The following European harmonized standards have been applied:
EN12100:2010
EN ISO 5210:1996
The relevant technical documentation for partly completed machinery referred to in Annex VII, Part B has
been prepared. The manufactor commits to submitting the documents for the incomplete machine the compe-
tent national authority electronically upon request.
For the preparation of the technical documents is authorized:
Head of mechanical Engineering
Schiebel Antriebstechnik Gesellschaft m.b.H.
Josef-Benc-Gasse 4
A-1230 Vienna
This partly completed machinery must not be put into service until the final machinery into which it is to
be incorporated has been declared in conformity with the provisions of the Machinery Directive 2006/42/EC,
where appropriate.
The electric actuators as partly completed machinery is in conformity with the relevant regulations of the EU
directives:
Directive 2014/30/EU ("'EMV-Directive"')
Directive 2014/35/EU ("'Low voltage directive"')
Directive 2014/34/EU ("'ATEX-Directive"')
The corresponding separate EC Declarations of Conformity are valid.
Vienna, den 14.12.2016
(location)

12 Original Declaration of Incorporation of Partly Completed Machinery

Josef-Benc-Gasse 4
A-1230 Vienna
exAB exrAB
Smartcon exCSC
1.1.2, 1.1.3, 1.1.5; 1.2.1, 1.2.1, 1.2.2, 1.2.6; 1.3.1, 1.3.2, 1.3.7;
1.5.1; 1.6.3; 1.7.1, 1.7.3, 1.7.4
EN ISO 5211:2001
for correspondingly marked devices
(date)
DIN 3358:1982
.........................................................................
(Klaus Schiebel, general manager)
SEC-EINBAUERKLAERUNG-ENGLISH-V2.01-2018.04.24
29