Technical Data; Binary Outputs; Binary Inputs - SCHIEBEL AB3 Operating Instructions Manual

Operating Instructions for Actuators Type AB with Control Unit
OM-ENGLISH-ABCSC.V1.2-16xx-V2.02-2023.04.27

15 Technical data

FL2
FL1
Figure 51: Control unit

15.1 Binary outputs

Count: . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 8
Power supply: . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 24 VDC nominal
Max voltage drop at set output: . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1 V
Output voltage at non-set output: . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . <1 V
Maximum current per output: . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 500 mA (short circuit proof)
Maximum permissible total current for all outputs: . . . . . . . . . . . . . . .4 A
Fuse (Fuse FL2, see Figure 52, page 33): . . . . . . . . . . . . . . . . . . . . . . 4 A slow
Binary outputs with external supply are separated from other controllers via optocouplers.
It is allowed to connect binary outputs in parallel. If the outputs have the same setting (textitsee Operating
Instructions for SMARTCON Control Units), the current of each output may be added together. If the settings
of the outputs are different, a hardwired logical OR is realized.

15.2 Binary inputs

Count: . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5
Nominal voltage: . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 24 VDC
Voltage for input set: . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . >10 V (8.5 V typ.)
Voltage for input not set: . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . <7 V (8.5 V typ.)
Maximum voltage: . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 30 VDC
Current consumtion at 24 VDC: . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 10.5 mA typ.
Binary inputs are separated from other controllers via optocouplers.
FL2
FL1
Figure 52: Logic-board
range: 11. . . 35 VDC
(either from internal or external)
(Littelfuse 454 NANO
towards common ground
15 Technical data
JP6
JP5
JP4
JP3
JP2
JP1
2 ®
Slo-Blo )
33