Starting Sky Command Ii+ Operation; To Exit Sky Command Ii+ Operation - Kenwood RC-2000 Instruction Manual

STARTING SKY COMMAND II+ OPERATION

1 Select an open 144 MHz frequency on the main
transceiver.
2 Select an open 440 MHz frequency for the sub-
receiver.
3 Press [F1] (1 s) until you select group A.
4 Press [F1] until you select A–3.
5 Press [MENU].
6 Turn the MULTI/ CH control to select Menu No. 62.
7 Press [SUB].
8 Turn the MULTI/ CH control to select Menu No. 62E.
9 Press [–]/ [+] to select either "COMMAND"
(Commander) or "T-PORTER" (Transporter).
10 The Sky Command II+ operation starts.
Note: "CLIENT" is used when you use another TM-D700A or TH-D7A for
the Transporter of the Sky Command operation. Refer to "USING A
SEPARATE TRANSPORTER" {TS-2000 page 88}.
46

TO EXIT SKY COMMAND II+ OPERATION

1 Press [MENU].
2 Press [–]/ [+] and select "OFF" to exit the Sky
Command II+ operation.