System Messages - KBL megaSun K7S Operating Instructions Manual

System messages

No. Status message
Mains frequency off limit.
004
Safety shutdown!
Canopy open. Please close
005
to return to normal operation.
Side open. Please close to
006
return to normal operation.
Bench open. Please close to
007
return to normal operation.
The maximum tanning time
008
is exceeded
Canopy overtemperature.
009 Please check the
ventilation system.
Overtemperature shoulder
012 area. Please check the
ventilation system.
Air outlet overtemperature.
013 Please check the ventilation
system.
Connection error control
044
board
Connection error DALI
045
board
Connection error EC fan
046
board
Auxiliary AC-fan control
047
board could not be started
Stop switch is activated.
051
Start of tanning not possible.
DALI board could not be
052
started.
Connection error AC fan
054
board
Control board could not be
055
started
ERROR MESSAGES
All error messages must be acknowledged with the OK key!
Description
A deviation was detected in the mains
frequency. Device has been switched off
for safety reasons.
Contact of the canopy pane and/or of the
filter cartridge cover has triggered.
Contact of the side pane has triggered.
Contact of the bench pane has triggered.
Coin-box system contact longer than the
value enabled under maximum tanning
time (voltage applied).
Canopy overtemperature.
Overtemperature shoulder area.
Air outlet overtemperature.
No response from CAN-BUS Receiver.
Emergency stop button (right side cap) is
activated or jammed.
Defect of the DALI circuit board.
No response from CAN-BUS Receiver.
Defect of the control board.
Remedy
Restart the control unit. Contact service after the third
unsuccessful restart.
Close canopy pane, check filter cartridge cover and
contacts.
Close the side pane and check the contact.
Close the bench / bench pane and check the contact.
Disconnect from the coin-box system.
Let the tanning device cool down.
Check filter inserts and clean if necessary.
Check the canopy ventilation system.
Let the tanning device cool down.
Check fan freewheeling.
Check the ventilation system in the air outlet.
Let the tanning device cool down.
Check fan freewheeling.
Check the ventilation system in the air outlet.
Check / replace patch cable.
Deactivate the emergency stop button or check the
function.
Contact your customer service.
Check / replace patch cable.
Contact your customer service.
Operating instructions | 1/2 | megaSun K5/K6/K7 PRODUCT SERIES
45