Feature Description; Intended Use; Use; Preparations Before Use - Dräger Oxy 3000 MK III Trainer Instructions For Use Manual

|

Use

3.1.2 Functional part
9
8
7
19
FOR TRAINING ONLY
7 Training heat exchanger
8 Mouthpiece
9 Neck strap (training)
10 Nose clip
11 Hose ring
12 O-ring (training)
13 Breathing hose
14 Starter (training)
15 Breathing bag
16 Cartridge (training)
17 Button loop
18 Goggles
19 Chest strap
3.2

Feature description

The training device consists of a casing with a simulated
functional part. In contrast to the oxygen self-rescuer, the
training device does not contain chemically bound oxygen.
The dimensions and weight of the training device approximate
those of the oxygen self-rescuer. The functional part
essentially corresponds to the structure of the oxygen self-
rescuer. The breathing bag of the training device does not fill
with oxygen. Instead, the training heat exchanger simulates
the respiratory resistance of the oxygen self-rescuer.
3.3

Intended use

The training device is exclusively intended for training
purposes. It is used for practising how to open, don and
breathe with an oxygen self-rescuer from the Dräger
Oxy 3000 and Dräger Oxy 6000 series.
16
4
4.1
10
The support ring, carrying strap and casing protector are
11
not included in the scope of delivery of the training device.
These can, however, be additionally ordered and assembled
so that the training device corresponds to the oxygen self-
rescuer. Assembly information can be found in the
12
instructions for use for the oxygen self-rescuer.
13
4.2
14
Donning the device incorrectly may cause a delay when
15
using the oxygen self-rescuer in emergencies. The following
16
exercises will improve your donning of the oxygen self-
rescuer which could save your life.
17
Be sure to perform the following steps in the described
sequence.
1. Pull the opener up and press it into its end position. The
tightening straps then release automatically.
18
reused.
The sealing tag for the oxygen self-rescuer breaks to show
that the device was opened.
2. Remove the upper part of the casing.
part of the housing. It is therefore easy to open. The
functional part is removed more easily than on the oxygen
self-rescuer.
For the oxygen self-rescuer, opening can be supported as
follows:
Use the fully opened opener to lever the lid open.
Or:
Bend the casing at the face seal. To do this, place the
device flat on the floor. Press on the edge of the upper and
lower parts of the casing.
In minus temperatures, support the opening with your feet
if necessary (analogous to the previous point).
Instructions for use
Use

Preparations before use

Donning procedure

The seal of the training device is elastic. It can be
The training device does not have a seal on the lower
|
Dräger Oxy 3000/6000 MK III Trainer