go-e Charger Gemini Installation And Operating Manual

go-e Charger Gemini Installation And Operating Manual

Hide thumbs Also See for Charger Gemini:

Advertisement

Quick Links

Installation
and operating manual
go-e Charger
Gemini
11/22 kW
Stationary wallbox/charging station for electric vehicles,
according to EN IEC 61851-1:2019, valid for article numbers:
CH-04-11-51, CH-04-22-51
V 1.4

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Charger Gemini and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for go-e Charger Gemini

  • Page 1 Installation and operating manual go-e Charger Gemini 11/22 kW Stationary wallbox/charging station for electric vehicles, according to EN IEC 61851-1:2019, valid for article numbers: CH-04-11-51, CH-04-22-51 V 1.4...
  • Page 2 36 Here you can find HOW-TO videos and product vi- deos. Our videos are available with subtitles in diffe- rent languages! Installation and operating manual go-e Charger Gemini V 1.4 Installation and operating manual go-e Charger Gemini V 1.4...
  • Page 3: Important Symbols

    With the go-e Charger, you only charge when the electricity is cheapest. Installation and operating manual go-e Charger Gemini V 1.4 Installation and operating manual go-e Charger Gemini V 1.4...
  • Page 4: Before Installation And Commissioning

    Installation must be carried out in accor- there is an increased danger from ammo- dance with local, regional and national re- nia gases. gulations. Installation and operating manual go-e Charger Gemini V 1.4 Installation and operating manual go-e Charger Gemini V 1.4...
  • Page 5 (IT grid, e.g. in many regions of Norway) so Installation and operating manual go-e Charger Gemini V 1.4 Installation and operating manual go-e Charger Gemini V 1.4...
  • Page 6: Product Overview

    • Type 2 cable (up to 22 kW) 2.5 m | 5 m | 7.5 m • Type 2 cable holder • RFID chips, pack of 10 • Additional go-e Charger wall bracket Installation and operating manual go-e Charger Gemini V 1.4 Installation and operating manual go-e Charger Gemini V 1.4...
  • Page 7: Technical Data

    Protected against dirt and water, suitable for permanent IP65 outdoor operation Impact resistance IK08 For authorised access by the electricity grid operator to the go-e Charger go-e network operator API for grid-serving power control Modbus TCP e.g. for grid-serving power control by the electricity v grid operator...
  • Page 8: Required Tools

    *Internet connection of the Charger required ling of well-being. **Contract with an electricity provider whose flexible electricity tariff is integrated in the go-e app is required. Several 100 tariffs are stored. The number of tariffs is constantly being expanded. Place the wall bracket in the desired mounting posi- tion.
  • Page 9: Installation

    In addition, a is possible. padlock (not included in the scope of delivery) can be attached. Installation and operating manual go-e Charger Gemini V 1.4 Installation and operating manual go-e Charger Gemini V 1.4...
  • Page 10: Starting The Charging Process

    Connect the go-e Charger and the vehicle by using a charging single-phase vehicles. type 2 charging cable (or if the car has a type one so- cket by using a type 2 to type 1 adapter cable).
  • Page 11 The go-e Charger waits to charge based on a preset the „Cable unlock“ setting in the app. However, it is sheduler or to obtain cheap electricity when charging then no longer theft-protected in the event of a pow- with a flexible electricity tariff.
  • Page 12 The LEDs flash red. The LEDs light up yellow at the bottom and flash red The go-e Charger has detected a general communica- tion error. Check the error code in the go-e Charger at the top. app. The temperature in the go-e Charger is increased.
  • Page 13: Firmware Update

    (below logo of the charger) before each charging process. Alternatively, authentication can be done by tapping the round button of the tab „Charging“ of the go-e Charger app. Installation and operating manual go-e Charger Gemini V 1.4 Installation and operating manual go-e Charger Gemini V 1.4...
  • Page 14 11. Reset card/RFID chip 12. App - connection setup Consumption overview for several users The go-e Charger can also be used without an app. Furthermore, additional user accounts can be created Download the go-e Charger app if you want to change with additional RFID chips (available as accessories).
  • Page 15 12. App - connection setup 12. App - charging Set up connection via WiFi The „Charging“ tab of the go-e Charger app gives you direct access to the most important functions for For remote control of the charger and for some com-...
  • Page 16: App Settings

    „Next Trip Mode“ under Mode and set a price, time or kWh limit at which the go-e Charger should start or below. finish charging for the selected charging mode in the Current levels „Settings“...
  • Page 17 Charger may charge or not char- ge. For weekdays, Saturday and Sunday, 2 time periods can be defined separately. Installation and operating manual go-e Charger Gemini V 1.4 Installation and operating manual go-e Charger Gemini V 1.4...
  • Page 18: Ce Declaration Of Conformity

    In the (justified) case of the return of the defective product to go-e, go-e will bear the costs incurred. If, in the event of a guarantee claim, it becomes apparent that the device needs to be replaced, the customer waives ownership of the previous device from the date of return shipment and the new device simulta- neously becomes the property of the buyer.
  • Page 19: Contact And Support

    If you cannot find an answer to your question in this guide, on our website or in the app, please feel free to contact us: Support Support go-e GmbH Satellitenstraße 1 9560 Feldkirchen AUSTRIA support@go-e.com +43 4276 6240010 www.go-e.com Installation and operating manual go-e Charger Gemini V 1.4...

Table of Contents