Connecting Cables; Digital Input; Analog Input - Eizo Radiforce MX240W Instructions For Use Manual

Connecting Cables

Note
• Check that the monitor and the PC are powered off.
• When replacing the current monitor with a MX240W monitor, be sure to change the PC settings
for resolution and vertical frequency to those which are available for the MX240W monitor referring
to the resolution table (back of cover page) before connecting the PC.
Tips
• When connecting two PCs to the monitor, refer to the User' s Manual on the CD-ROM.
1
Connect the monitor to the PC with a signal cable that matches the connectors.
After connecting the cable connectors, tighten the screws of the connectors to secure the coupling.

Digital Input

Connectors on the monitor

Analog Input

Connectors on the monitor
2
Connect the USB cable when using RadiCS LE or ScreenManager Pro for
Medical.
Connecting to the Monitor
3
Plug the power cord into a power outlet and the power connector on the monitor.
4
Press to turn on the monitor.
The monitor's power indicator lights up blue.
5
Turn on the PC.
The screen image appears.
If an image does not appear, refer to "No-Picture Problem" (page.6) for additional advice.
6
When using analog input signals, perform the Auto Adjustment function (Refer to
Performing Auto Adjustment function
"
The Auto Adjustment function is not necessary when digital signals are input because images are
displayed correctly based on the preset data of the monitor.
Power cord
Digital/Analog signal cable
Signal cable FD-C39
Signal cable FD-C16
USB cable
cable Connectors on the PC
cable Connectors on the PC
Connecting to a Computer
below).
"
3