Section 4. Using The Mon08 Interface; Contents; Overview; Target System Header Placement And Layout - Motorola M68LC302CAF20VCT User Manual

User's Manual - M68ICS08RK In-Circuit Simulator

4.1 Contents

4.2 Overview

4.3 Target System Header Placement and Layout

M68ICS08RK In-Circuit Simulator - Rev. 1
MOTOROLA

Section 4. Using the MON08 Interface

4.2 Overview. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 45
4.3 Target System Header Placement and Layout . . . . . . . . . . . . . . . . . . 45
4.4 Connecting to the In-Circuit Simulator. . . . . . . . . . . . . . . . . . . . . . . . 47
4.5 Disabling the Target-System Interface . . . . . . . . . . . . . . . . . . . . . . . . 47
4.6 Sample Application. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 48
The MON08 debugging interface may be used to debug and program a target
system's MCU directly. The target system must be connected to the
M68ICS08RK in-circuit simulator board's MON08 interface connector. This
section explains how to connect to the MON08 interface on the target board.
Two headers must be placed on the target board:
• P1 - 16-pin header such as Berg Electronics part number 67997-616
• P2 - 1-pin header such as Berg Electronics part number 68001-601
Table 4-1 and Table 4-2 show the target-system interconnections for P1 and
P2. Figure 4-1 shows the pin layouts for P1 and P2. Additional information
about the connections on the RKICS board can be found in Appendix B.
Technical Reference and Troubleshooting.
Using the MON08 Interface
User's Manual
45