Rkics Board - Motorola M68LC302CAF20VCT User Manual

Technical Reference and Troubleshooting
B.3 RKICS Board
NOTE:
User's Manual
56
The core component of the board is the MC68HC908RK2 MCU. This MCU
resides either on the RKICS board or on a target system.
When the MCU resides on the board, the board may be used as an in-circuit
emulator or simulator for the MC68HC908RK2. For this configuration, a target
cable is run from the board to the target system.
The M68ICS08RK supports two kinds of target cables:
• A 20-pin ribbon cable (Motorola part number 01-RE9065W01),
terminating in a 20-pin male DIP (dual in-line package) header
The 20-pin ribbon cable is included in the kit and cannot be ordered separately.
• A flexible target head adapter cable (Motorola part number
M68CBL05A), terminating in connectors for one of three target head
adapters. This cable must be ordered separately. Four target head
adapters (THAs) are available for use with the flex cable:
– For a 20-pin SOIC-package (small outline integrated circuit) MCU
on the target system, use Motorola THA model number
M68DIPSOIC.
– For a 20-pin SSOP-package (shrink small outline package) MCU on
the target system, use Motorola THA model number
M68DIP20SSOP.
– For a 32-pin QFP-package (quad flat pack) MCU on the target
system, use Motorola THA model number M68TC08RKFU32.
– For a 20-pin SOIC- or SSOP-package MCU on the target system, use
Motorola THA M68TC08RK2P20. Use only with flex cable A,
Motorola part number M68CBL05A.
Using a target cable is optional; the board may be utilized with flying leads to
other circuits. The MCU can be either the 20-pin SOIC or SSOP version or the
32-pin QFP version. On the RKICS board, socket XU1 supports the 20-pin
SSOP package, socket XU2 supports the 20-pin SOIC package, and socket XU3
supports the 32-pin QFP package.
Technical Reference and Troubleshooting
M68ICS08RK In-Circuit Simulator — Rev. 1
MOTOROLA