Table of Contents
Advertisement
2.4 Installing the Built-in Computer
The built-in computer does not support hot-plugging. Therefore, you must insert or remove the built-in computer
when the display is powered off. Otherwise, the display or built-in computer may be damaged.
Perform the following steps to install the built-in computer：
Step1 Unscrew the screws by hand to remove the built-in computer shielding cover.
This step is optional and applies to models with shielding cover.
Step2 Push the built-in computer into the port at the rear of the machine from right to left.
Step3 Secure the built-in computer to the machine by using the screws.
If the screen fuzzes, flashes, or if no signal is received from the built-in computer channel after turning on the power, it means that
the built-in computer has not been properly installed. Please check it and re-install.
19
Advertisement
Table of Contents
