Table of Contents
Advertisement
CHAPTER 2: ASSEMBLY INSTRUCTIONS
BIKE ASSEMBLY STEPS (continued):
Power Supply Installation Step D (secure the power supply):
•
To install each wire-tie, first wrap underneath
the square frame tube behind the Power
Supply
•
Then slide the wire-tie forward into position
Power Supply Installation Step E (secure the power supply):
•
•
•
Truefitness.com / 800.426.6570 / 636.272.7100
Secure the Power Supply to the square frame tube using 2
wire-ties (positions shown, above)
Wire-ties should also secure the extra Power Supply
cables
Verify that there is no interference between the wire-ties
or cables and the moving brake flywheel
•
Insert the Access Plastic
•
Re-install the Access Plastic
fasteners (quantity 3) with a
Phillips head screwdriver
(not provided)
28
Advertisement
Table of Contents
