True Fitness CS400-9 Owner's Manual page 15

CHAPTER 2: ASSEMBLY INSTRUCTIONS
BIKE ASSEMBLY STEPS (continued):
Step 3 Seat Saddle:
Preparation for Step # 4:
•
Remove the flat washers and nuts from the 3 threaded rods on
the bottom of the Seat Saddle
• Insert Seat Saddle onto the Seat Post Mounting Plate; the
threaded rods on the bottom of the Seat Saddle will align with
the 3 openings on the Seat Post Mounting Plate
• For each threaded rod, install flat washer followed by nut
• Tighten using the provided wrench
•
Install the Mast Boot component (including rubber gasket)
onto the Front Mast tube
• Verify that the Mast Boot is installed in the correct orientation
(reference the provided image, left)
Truefitness.com / 800.426.6570 / 636.272.7100 11