Battery Maintenance; To Replace The Batteries - Husqvarna Blastrac BMG 2200RC Operator's Manual

6.11

Battery maintenance

The machine is equipped with 6 batteries 4 GBV 180 EV 8 Volt, 180 Ah.
They are sealed, maintenance-free batteries that are non-hazardous, non-spillable and are made from~80%
recycled materials. During normal operation batteries do not release any harmful gasses and there is no leakage
of acidic electrolyte into the environment.
Only use Husqvarna approved batteries. Husqvarna cannot guarantee the safety of the machine when other
batteries are used.
Warning: Only trained personnel servicing the batteries. High amperage exist and can cause serious injury or
death.
Immediately flush eyes with cold, fresh water for a minimum of 10 minutes if electrolytic acid comes in contact
with eyes. Seek professional medical attention immediately.
Use isolated tools when you replace battery or do the maintenance.
Do not wear jewellery like rings, watches, necklaces etc. if you work with batteries. They can cause a serious
burns. Batteries are heavy (around 37 kg). When you remove batteries, ask someone for help or use a lifting
device. Do not drop.
If you replace the batteries, make sure that use the wiring diagram in the service manual. Do not mix new
batteries with the old batteries in the machine. It is recommended to replace all batteries at the same time. The
batteries contain lead-acid, do not disassemble, heat above 60°C, or incinerate. The old batteries not domestic
waste. Batteries contain harmful materials, for example lead and sulphuric acid. These materials form an
environmental and health hazard. It is not permitted to dispose this product as normal household waste. Obey
the local recycling requirements and applicable regulations.
6.12

To replace the batteries

Remove the batteries
1. Make sure the tools are good isolated. If they are not this can result in serious damage, injuries or dead.
2. Disconnect all the wires from the top batteries.
3. Take the lit for the side of the top container.
4. Remove the top batteries.
5. Remove the container.
6. Disconnect all the wires of the lower batteries.
7. Remove the lower batteries.
Install the batteries
1. Make sure the tools are good isolated. If they are not this can result in serious damage, injuries or dead.
2. Place the lower batteries.
3. Connect the batteries as shown in the drawing.
4. Place the isolation and container.
5. Place the top batteries.
6. Close the lit in the container
7. Connect the top batteries as shown in the drawing.
48
6x Part number:
E09174 - Battery
21.07.2023