Maintenance - Husqvarna BMC 335 Operator's Manual

3. Turn the tracking control (C) for small adjustments of
the direction of movement.
C
Note:
The joystick can also be used when the
cruise control function is on.
4. Push the cruise control button (A) again to stop the
cruise control function.
To stop the product
1. Pull the lift lever up.
Introduction
WARNING:
maintenance, you must read and
understand the safety chapter.
For all servicing and repair work on the product, special
training is necessary. We guarantee the availability of
1816 - 001 - 05.04.2022

Maintenance

Before you do
2. Turn the depth adjustment wheel until the tool drum
does not touch the ground.
3. If you operate the product with the control panel, do
this step:
a) Push the OFF button for the drive motor and the
OFF button for the drum motor.
4. If you operate the product with the remote control, do
these steps:
a) Set the joystick in neutral position to stop the
movement of the product.
b) Push the stop button for the drum motor (A).
c) Wait until the display (B) shows "0" for both RPM
and Amp.
5. Wait until all moving parts are fully stopped.
6. Stop the dust extractor.
7. Disconnect the power plug.
professional repairs and servicing. If your dealer is not
a service agent, speak to them for information about the
nearest service agent.
Maintenance schedule
* = General maintenance done by the operator. The
instructions are not given in this operator's manual.
X = The instructions are given in this operator's manual.
0mm 10 20 30
0 RPM
0 Amp
B
A
19