Table of Contents
Advertisement
6.8
Blower motor
The dust collector has the powerful 13.8 kW blower motor
(1).
The inlet is equipped with a limit valve (2) to safe the
blower motor. If you change the settings of this limit valve,
it will void any warranty.
From the inlet of the blower motor a dust hose goes to the
upper part of the dust collector where the air goes through
the filters.
From the dirty side of the filters is a connection from the
upper part of the pre-separator.
From the side entrance of the pre-separator is a dust hose
to connect the junction (3) of the 3 dust hoses from the 3 grind heads.
The outlet of the blower motor blows the air
through the oversized HEPA-filter, that cleans
99,995% of the airborne particles
0.3 micrometers (µm) in diameter.
The connections in the junction (3) are:
I
= Grind head LEFT
II = Grind head MIDDLE
III = Grind head RIGHT
21.07.2023
= Lowest connection
= Middle connection
= Highest connection
1
Outlet
Inlet
III
II
I
2
3
43
Advertisement
Table of Contents
