Table of Contents
Advertisement
1
5.5
Start grinding
Refer to fig. in chapter Operation on page 19.
1. Sit down in the control seat and fasten the seatbelt.
•
The seat is equipped with a sensor that will detect if a person is present in the control seat.
2. Do a check if there are any faults in the error / warning menu.
3. Start the compressor (7).
•
The compressor builds up pressure needed for operation.
4. Loosen the quick release pins which hold the grind heads in the UP-position.
•
It could be possible that the fingertip toggles (12) need to be operated if the quick release pins
won't come loose.
5. Start the dust collector (10).
•
Make sure that the Longopack bags are empty and in correct position.
6. Press "FREEFLOW" (13), or lower the grind heads with the fingertip toggles (12).
•
The grind heads will lower to the surface. (Grind heads must be activated in the system menu, items
26, 27 and 28, refer to fig. on page 20).
7. Make sure that the Head Pressure selection (24, refer to fig. on page 20) is set to -20 before you start.
8. Press "START GRINDING" (6).
•
The grind heads turn.
9. Use the joysticks (1) and (9) to start driving.
•
Use the button (2) on top of the left-hand joystick (1) to activate the cruise control.
•
Use the "DRIVE SPEED" turning knob (11) to adjust the drive speed in cruise control mode.
10. Observe the main screen to see the RPM's and Amps of the grind heads.
•
Adjust the RPM's of the grind heads with the "GRINDER SPEED" turning knob (3).
In case of emergency or operating trouble, for example vibrations or strong noises, set the machine to off
immediately!
Refer to chapter "Stop grinding" or push the red emergency button above the touch screen.
5.6
Stop grinding
Refer to fig. in chapter Operation on page 19.
1. Stop driving.
•
Put the left-hand joystick (1) in the centre position to stop the machine.
2. Stop grinding.
•
Press the "STOP GRINDING" button (8) to stop grinding.
3. Stop the freeflow.
•
Press the "FREEFLOW" button (13) to stop the freeflow. The freeflow indication on the Touchscreen
comes off.
4. Move up the grind heads.
•
Use the fingertip toggles (12) to move up the grind heads and secure the grind heads in the UP
position with the quick release pins.
5. Stop the dust collector.
•
Push the "DUST COLLECTOR" button (10) to stop the dust collector. The little light in the button
goes off.
6. Stop the compressor.
•
Push the "COMPRESSOR" button (7) to stop the dust collector. The little light in the button goes off.
7. Use the ignition key (14) to set the machine to off and disconnect the power supply.
24
3
3
2
4
21.07.2023
Advertisement
Table of Contents
