6.2 Grinding head
6.2.1 To remove the grinding head
To remove the tool holder assembly, use an internal
puller and an extension. Refer to
overview on page 7 .
1. Remove the screw that attaches the holder
assembly to the motor shaft, with an impact wrench .
2. Put the internal puller claws (A) on the inner edges
of the center hole of the holder. Put the extension
(B) on the motor shaft (C).
12 - Repair and servicing
Servicing tools
A
B
C
3. Remove the tool holder assembly from the motor
shaft slowly to prevent damage to the vibration
damping units.
4. Remove the tool holder assembly.
1022 - 002 -