Configuration Interface - E+E Elektronik HTS801 User Manual

Probe connection / socket
Standard cable gland / connector
Fig. 2 HTS801 connector-side view
Back section
Connection terminal block
Back section
Space for optional modules
Fig. 3 HTS801 modular polycarbonate enclosure inside view
3.3

Configuration Interface

The HTS801 is ready to use and does not require any configuration by the user. The factory setup of HTS801
corresponds to the type number ordered. Please refer to the datasheet at www.epluse.com/hts801. If needed, the
user can change the factory setup with the
▪.
Free PCS10 Product Configuration Software.
Please refer to chapter 6.1 PCS10 Product Configuration Software.
▪.
Display and push-buttons (if the optional display is selected)
Please refer to chapter 1.2.1. General Safety Instructions.
▪.
Modbus RTU protocol (if the RS485 option is selected).
Please note that configuration is limited to the Modbus communication settings.
Please refer to chapter 6.2 RS485 Digital Interface.
USB service interface
*)
Standard cable glands / connectors
*)
*) Depending on electrical connection options
Front section
Mounting plate
Front section
Back section
*)
RS485 add-on chip
Humidity and Temperature Sensor for High Humidity and Chemically Polluted Conditions | 9
User Manual HTS801