Servicing; Return To Factory; Maintenance - Setra Systems 355X Series Operating & Installation Instructions

Table of Contents

SERVICING

The transducer cannot be repaired locally and if damaged should be returned to Setra Systems, Inc at the

address shown below or to accredited dealers when a replacement/repair is required:

Please Note: To comply with Health and Safety requirements, the instrument must be clean and safe to

handle and accompanied by a formal statement to that effect duly signed by an authorized officer of the

company.

Any instrument returned without certification will be quarantined and no action will occur until cleared. It

may ultimately be returned to you and subject to a transportation charge.

Routine Inspections: Not required except for periodic inspection of the cable and connector to ensure that

these are neither damaged nor softened by incompatible liquid.

For all CE technical questions, contact Setra Systems, USA. EU customers may contact our EU representative

Hengstler GmbH, Uhlandstr. 49, 78554 Aldingen, Germany (TEl: +49-7424-890, Fax: +49-7424-89500)

Phone: 800-257-3872 • Fax: 978-264-0292 •

Setra Systems, Inc.

159 Swanson Rd

Boxborough, MA 01719

U.S.A

www.setra.com

Table of Contents

Do you have a question about the 355X Series and is the answer not in the manual?