Timer; Setting A Start Time; Using The Timer; Hand Alignment Adjustment - Casio 5682 Operation Manual

Table of Contents

Advertisement

Timer

The timer counts down from a start time
specified by you. A beeper sounds when the
end of the countdown is reached.
The beeper will not sound if battery power
is low.

Setting a Start Time

The start time can be set in 1-minute units up
to 60 minutes.
1.
Enter the Timer Mode.
Navigating Between Modes
l
2.
Pull out the crown.
This causes the minutes digits to flash.
Minutes
3.
Rotate the crown to change the timer start
time minutes.
4.
Push the crown back in to complete the
setting operation.
Note
If you do not perform any operation for
about two minutes after pulling out the
crown, crown operations will
automatically become disabled. If that
happens, push the crown back in and
then pull it out again.
Watch Operation Guide 5682

Using the Timer

1.
Enter the Timer Mode.
Navigating Between Modes
l
2.
Use the operations below to perform a
timer operation.
A beeper will sound for 10 seconds to
let you know when the end of a
countdown is reached.
You can reset a paused countdown to
its start time, by pressing (C).
3.
Press any button to stop the tone.
Crown
A
Start
(Countdown starts)
A
Pause
A
Resume
(Time up)
Hand Alignment
Adjustment
Strong magnetism or impact can cause the
time indicated by the analog hands to become
different from the time on the display. If this
happens, adjust hand alignment.

Adjusting Hand Alignment

1.
Enter the Timekeeping Mode.
Navigating Between Modes
l
2.
Pull out the crown.
This causes [CITY] to flash on the display
and the second hand to move to the
current Home City.
Second hand
Home City
3.
Hold down (A) for at least five seconds.
Release the button when [HAND ADJ]
starts to flash.
This indicates that hand alignment
adjustment has started.
[HAND SET] will flash first on the
display about 0.5 seconds after you
hold down the (A) button. Keep the
button depressed until [HAND ADJ]
flashes on the display.
After 0.5 seconds
After five seconds
4.
After all the hands move to 12 o'clock,
push the crown back in.
This returns the hands to normal
timekeeping.
Crown
31

Advertisement

Table of Contents
loading

Table of Contents