Table of Contents
Advertisement
Rear Mount Assembly
A cylinder can be attached vertically to the soft pack on the rear of the BC (Fig.
6). This configuration allows for larger cylinders to be used when needed.
1. Place the soft pack on a flat surface
with the rear cylinder mount face-up
(Fig. 6).
NOTE: The long cylinder bands must be used to set-up a rear cylinder
mount configuration.
2. Position the ribbed side of the traction sleeve face up. Insert the open end of the
cylinder band into left side of the traction sleeve, under the rear cylinder mount
straps and out the right side of the traction sleeve (Fig. 7). The traction sleeve
should be positioned directly over the rear cylinder mount (Fig. 8). Repeat process
for other cylinder band.
Fig. 7
Fig. 6
Fig. 8
9
Advertisement
Table of Contents
