Table of Contents
Advertisement
POST-USE CARE AND MAINTENANCE
1. Avoid prolonged exposure to direct sunlight and extreme heat. Nylon fabric can
quickly fade when exposed to the sun's ultraviolet rays and extreme heat may
damage the welded bladder seams.
2. Avoid repeated or prolonged use in heavily chlorinated water, which can cause
the BC fabric to discolor and decay prematurely.
3. Do not allow the BC to chafe against any sharp objects or rough surfaces that
could abrade or puncture the bladder. Do not set or drop heavy objects such
as block weights on the BC.
4. Avoid any contact with oil, gasoline, aerosols or chemical solvents.
5. To preserve the life of the bladder, rinse it inside and out with fresh water after
every day of use, using the following procedure:
•
Pressurize the power inflator with medium pressure (MP) air via the MP hose.
CAUTION:
air. This will prevent debris and contaminants from entering the valve
mechanism if the inflator button is accidentally depressed.
•
Using a garden hose, direct water through the oral inflator mouthpiece to
flush the interior of the bladder and then thoroughly rinse the exterior of
the BC.
•
Swish the water around to remove any mineral deposits, then invert the BC
so the inflator mouthpiece is the lowest point. Completely drain the bladder
of water through the oral inflator.
•
After rinsing, inflate the BC and allow it to dry inside and out.
•
Fully inflate the BC and set aside for 10 minutes. Check the firmness of
the BC after the time has elapsed. If leakage is detected, return the BC to
maintenance personnel for inspection.
Storage
Store the BC partially inflated, away from direct sunlight and in a clean, dry area.
Do not store the BC in an enclosed space, such as a car trunk, where temperatures
may fall below -18ºC / 0ºF or rise above 49ºC / 120ºF.
Transport
Do not allow the BC to chafe against any sharp objects or rough surfaces that
could abrade or puncture the bladder. Do not set or drop heavy objects such as
block weights on the BC. This BC should be exposed to temperatures no lower
than -20°C / -4°F and no higher than 65°C / 150°F.
Before rinsing, ensure that the inflator is pressurized with
21
Advertisement
Table of Contents
