Foam Maker - Fast UT3P25 Owner's Manual

Foam Maker

If you do not get foam:
1. Be sure the air line and liquid lines do not have a hole in them or are not pinched, remove
air and liquid tubing at each foamhead, and check for flow.
2. Be sure you have enough foam concentrate in the tank. Very hard water may require a
great amount of concentrate to produce good foam. Not having enough foam concentrate
in the tank may make good foam but may not make enough foam. Be sure to use a high-
quality concentrate such as GOODMARK.
3. Check and clean the screen-strainer located in the tank.
4. Be sure the flow control valve is open.
5. If the foam mixture in the tank is several days old, it is possible that the solution is no
longer able to foam or produces little foam. Drain tank, rinse, and start with a fresh solution.
6. Check the battery connections to be certain that the positive and negative terminals are
not reversed.
Problem
Not enough foam
Wet foam
Foam is surging
Foam does not last on the
ground
Blowing foam in windy weather
TROUBLESHOOTING
Solution
Add more foam concentrate to tank
Check for holes in airline
Check for pinched air or liquid lines
Clean screen-strainer/foamhead
Adjust liquid flow control valve
Add more foam concentrate to tank
Clean screen-strainer/foamhead
Reduce liquid flow
Use less concentrate
Add more foam concentrate to tank
Use a high-quality foam concentrate like GOODMARK
Use collector heads
Use less concentrate to make wetter foam
Add more water to foam solution
Increase liquid flow
Utility Sprayer 25' / 30' / 40' / 45'
TROUBLESHOOTING
Page 99