Thank you for choosing and purchasing our products. Please carefully read the operating instructions before use, for correct application and satisfactory results. TABLE OF CONTENTS 1. Introduction ............................General and safety information ..................Specifications ............................2. Unpacking and Setup ......................EEH2 Contents ..............................
1. INTRODUCTIO General and Safety In 1. Introduction ▪ For use in dry e General and Safety Information ▪ This product us • For use in dry environments only Read and unde ▪ • This product uses 4xAA batteries. Dispose of according to local laws and regulations. manual for futu •...
Page 4
Specifications Model EEH4 Max Capacity 6kg (12 lb) Readability 1g (0.002 lb) Display Resolution 1:6000 Min. Recommended Weight 20g (0.1 lb) Construction Stainless steel pan, plastic housing Weighing Units kg / lb / g / oz / lb:oz Calibration Unit...
2. Unpacking and Setup 2. Unpacking and Setup ▪ Remove the scale from the box and place it on a firm, level surface. Avoid locations with rapid temperature changes, excessive dust, moisture, air currents, vibrations, • Remove the scale from the box and place it on a firm, level surface. Avoid locations with rapid electromagnetic fields, heat or direct sunlight.
3.3 Key Functions 3.3 Key Functions 3.3 Key Functions 3.3 Key Functions EEH2 EHW-CM Operation Manual Functions Button Functions Button Button Functions Short Press: (when off) Power on the scale Functions Button Short Press: (when off) Power on the scale (when on) Sets display to zero Short Press: (when off)
4. Operations 4.1 Power on/Power off scale • Place the scale on a flat, stable surface. Level the scale using the leveling bubble at the lower left side of the display. • With the weighing platter empty, press the ON/OFF/ZERO key to power on the scale. The self-check will run, show the version number display full capacity e.g.
4.5 Switching measuring unit • In normal weighing mode, press and hold TARE/UNIT key to switching the measuring units between lb, kg, g, oz, lb:oz 5. Calibration 1. Prepare standard weights and make the scale with no load. 2. When the scale is off, press and hold down TARE/UNIT button, and then press ON/OFF/ZERO button at the same time until appears.
7. Display Symbol Meaning 0 ----------- : Power on zero-point is over (calibration zero-point) +20%FS) when scale is turned on, or the reading weight is over (power on zero-point) +5%FS when pressing ZERO button; 0 ----------- : Power on zero-point is below (calibration zero-point) -20%FS) when scale is turned on, or the reading weight is + (power on zero-point) -5%FS when pressing ZERO button;...
Need help?
Do you have a question about the EEH4 and is the answer not in the manual?
Questions and answers