Supplier's Declaration Of Conformity - KidKraft ADVENTURE BEND SWING SET Installation And Operating Instructions Manual

page of 180

/ 180
Contents
Table of Contents
Bookmarks

Table of Contents

Battery Instruction and Warranty

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

(1) This device may not cause harmful interference, and (2) this device must accept any interference received, includ-

ing interference that may cause undesired operation.

NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to

part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in

a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed

and used in accordance with the instructions, may cause harmful interference to radio communications. However,

there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful

interference to radio or television reception, which can be determined by turning the equipment off and on, the user

is encouraged to try to correct the interference by one or more of the following measures:

- Reorient or relocate the receiving antenna.

- Increase the separation between the equipment and receiver.

- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

- Consult the dealer or an experienced radio /TV technician for help.

Note: Changes or modifications not expressly approved by the manufacturer responsible for compliance could void

the user's authority to operate the equipment.

Please retain the information on this pack for future reference.

- Batteries should always be installed and changed under adult supervision.

- Non-Rechargeable batteries are not to be recharged.

- Rechargeable batteries are only to be charged under adult supervision.

- Only batteries of the same equivalent type as recommended are to be used.

- Batteries are to be inserted with the correct polarity.

- Exhausted batteries are to be removed from the toy and disposed of properly.

- The supply terminals are not to be short circuited.

- Different types of batteries or new and used batteries are not to be mixed.

- DO NOT mix alkaline, standard (carbon-zinc) or rechargeable batteries.

- Be sure to insert new batteries with positive (+) side up.

- Rechargeable batteries are to be removed from the toy before being charged.

- EU Regulations require exhausted batteries to be separately collected so that they can be treated using the best

available recovery and recycling techniques. This will minimize the impact on the environment and human health from

soil and water contamination by any hazardous substances, decrease the resources required to make new products and

avoid using up landfill space.

- Batteries or battery packs must be recycled or disposed of properly. When the batteries in this product have reached

the end of their useful life, they should not be disposed of with other household waste.

- Please do your part by keeping waste batteries out of the municipal waste stream!

Unique Identifier: F29720

Party issuing Supplier's Declaration of Conformity

Responsible Party - U.S. Contact Information

KidKraft, Inc.

4630 Olin Road

Dallas, Texas 75244 U.S.A.

customerservice@kidkraft.com

1(800) 933-0771 / (972) 385-0100

Identificateur unique : F29720

Partie délivrant la déclaration de conformité du fournisseur

Partie responsable - Coordonnées de la personne à contacter

aux É.-U.