Table of Contents
Advertisement
1
3
2
Figure 16
1. Upper tube
2. Middle tube
3. Bolt, 1/4 x 3/4 in.
Installing the Decal
1. Clean an area on the left–hand tractor frame for the
decal (Fig. 17)
2. Install the decal on the tractor frame (Fig. 17)
Figure 17
1. Decal
Installing the Front Wheel
Weights
Caution
The bagger adds a lot of weight to the rear of the
machine, causing a potential unstable condition
which could result in a loss of control.
Install the front wheel weights.
Contact an Authorized Service Dealer for the correct front
wheel weights needed with the collector.
4
5
m-5957
4. Flange nut, 1/4 in.
5. 9/32 in. hole
1
2
m-5950
2. Left–hand tractor frame
11
Operation
Note: Determine the left and right side of the machine from
the normal operating position.
Warning
To avoid personal injury, follow these procedures:
Become familiar with all operating and safety
instructions in the operator's manual for your
mower before using this attachment.
Never remove the collector or collector tubes
while the engine is running.
Always shut the engine off, remove the key, and
wait for all moving parts to stop before clearing
an obstruction from the bagging system.
Never do maintenance or repairs while the
engine is running.
Warning
Without the grass deflector, collector tubes or
complete collector assembly mounted in place, you
and others are exposed to blade contact and
thrown debris. Contact with the rotating mower
blade(s) and thrown debris will cause injury or
death.
Never remove the grass deflector from the
mower because the grass deflector routes
material down toward the turf. If the grass
deflector is ever damaged, replace it
immediately.
Never put your hands or feet under the mower.
Never try to clear the discharge area or mower
blades unless you move the power take off
(PTO) to off and rotate the ignition key to off.
Also remove the key and pull the wire off of the
spark plug(s).
Empty the Quiet Collector
1. Disengage the quiet collector PTO control (Fig. 20).
2. Disengage the mower PTO and set the parking brake.
Note: If the PTO is engaged, it is impossible to open the
collector due to the vacuum action inside.
3. Squeeze the collector lever on the collector arm
(Fig. 18).
Advertisement
Table of Contents
