Table of Contents
Advertisement
QB-RL78G1F In-Circuit Emulator
- I/O port output signal level detection function
I/O port output signal level detection function emulation is not supported.
Even if you set as "Output data is read (PMS0=1)" at port mode select register (PMS), the value of the port
register (Pnm) is read.
Remark n = 0 to 7,12 to 14 , m = 0 to 7
- Pull-up
There is a time lag (max 120ns) to work pull up register after setting PUx register.
- Setup time of SI00 in a master mode of CSI is needed more than a device.
Setup time of SI00 in a master mode of CSI is needed more +3ns than a device spec. It cause by delay of Probe
and Socket.
R20UT3352EJ0100 Rev.1.00
Jan 30, 2015
CHAPTER 4
CAUTIONS
Page 36 of 41
Advertisement
Table of Contents
