Renesas QB-RL78G1F User Manual page 10

QB-RL78G1F In-Circuit Emulator
(1) TCN1, TCN3
These are connectors for connecting a check pin adapter or emulation probe.
(2) OSC1
This is a socket for mounting the oscillator.
(3) CN6, TCN4
These are connectors for the shipment inspection. User does not need to use these connectors.
(4) POWER (Red LED)
This is an LED that shows whether the power supply of the QB-RL78G1F is switched on.
LED State
Lit
Not lit
Blinking
(5) TARGET (Green LED)
This is an LED that shows whether the power supply of the target system is switched on.
LED State
Lit
Not lit
(6) Power switch
This is the power switch of the QB-RL78G1F.
It is OFF at shipment.
(7) Cooling fun
This is the cooling fun of the QB-RL78G1F.
It works when the power supply of the QB-RL78G1F is switched on.
R20UT3352EJ0100 Rev.1.00
Jan 30, 2015
Table 1-2. QB-RL78G1F POWER LED
Power switch ON
Power switch OFF or AC adapter not connected to QB-RL78G1F
Internal error occurred (Contact an Renesas Electronics or
Table 1-3. QB-RL78G1F TARGET LED
Target system power supply ON
Target system power supply OFF or target system not connected
QB-RL78G1F State
distributor)
Target System State
CHAPTER 1 GENERAL
Page 10 of 41