Mating Thetc To Ea - Renesas QB-RL78G1F User Manual

QB-RL78G1F In-Circuit Emulator

2.3.2 Mating theTC to EA

Mate the TC and EA by following the procedure below.
(1) Check the orientation of pin 1, align the TC guide pin to the guide hole at the tip of the EA flexible printed circuit
(FPC), and then insert it. (See Figure 2-5)
(2) Check conductivity between the TC and EA at this time.
(3) Solder the TC to the guide locking pad that can be seen from the FPC tip flexible guide hole using a soldering
iron with a tip radius of φ1.0 mm or smaller. (Once soldered, the TC and EA cannot be removed from each
other.)
(4) Use extreme care so that the EA (FPC cable) does not apply stress to the TC. If the EA applies even a small
amount of stress to the TC, we recommend securing the section soldered to the TC board with adhesive.
Tip of EA
Figure 2-5 Magnified guide hole view when TC and EA are mated & mating diagram.
R20UT3352EJ0100 Rev.1.00
Jan 30, 2015
Magnified view: The guide pin can be seen when the TC and EA are mated
CHAPTER 2 SETUP PROCEDURE
EA
TC
When the EA and TC are mated
Page 23 of 41