Sherwood RD-6504 Operating Instructions Manual page 33

RD-6504(G):RD-6504(G) 2009-02-12 오
When selecting the TONE
OFF : To listen to a program source without the tone effect. ("DIR" indicator lights up.)
↕
ON : To adjust the tone for your taste. ("DIR" indicator goes off.)
■Note :
• When the EXTERNAL IN is selected as an input source, the TONE cannot be set to ON.
■When the TONE is set to ON to adjust the tone (bass and treble)
① Press the ENTER button to enter the tone adjustment.
② Press the CURSOR UP(▲)/DOWN(▼) buttons to select the desired tone.
③ Press the CURSOR LEFT(◀)/RIGHT(▶) buttons to adjust the selected tone as desired.
When selecting the HDMI
• The HDMI connection can carry uncompressed digital video signals and digital audio signals.
Depending on whether the digital audio signals input into the HDMI IN are output from the HDMI MONITOR OUT of this
receiver or not, you should set the HDMI correctly.
OFF : Not to output the HDMI digital audio signals from the HDMI MONITOR OUT of this receiver, meaning these signals
↕ are heard from the speakers connected to this receiver.
ON : To output the HDMI digital audio signals from the HDMI MONITOR OUT, meaning these signals are heard from the
speakers of your TV.
■Note:
• When the HDMI is set to ON, the HDMI digital audio signals will not be heard from the speakers connected to this receiver
even though the HDMI audio input ("H") is selected for VIDEO 1 or VIDEO 2.
9:35 페이지 33
All manuals and user guides at all-guides.com
• The tone level can be adjusted within the range of -12 ~ +12 dB.
• In general, we recommend the bass and treble to be adjusted to 0
dB (flat level).
• Extreme settings at high volume may damage your speakers.
• To complete tone adjustment, repeat the above steps ② and ③.
33