Sherwood RD-6504 Operating Instructions Manual page 16

RD-6504(G):RD-6504(G) 2009-02-12 오
Adjusting the tone (bass and treble)
9.
Enter the tone mode.
• The tone mode is displayed for several seconds.
10.
Press the CURSOR LEFT(◀)/RIGHT(▶) buttons to
select the desired tone mode.
• Each time these buttons are pressed, the tone mode is
selected as follows :
OFF : To listen to a program source without the tone
↕ effect. ("DIR" indicator lights up.)
ON : To adjust the tone for your taste.
("DIR" indicator goes off.)
■Note :
• When the EXTERNAL IN is selected as an input source,
the TONE cannot be set to ON.
9:35 페이지 16
All manuals and user guides at all-guides.com
16
■When the TONE is set to ON to adjust the tone
(bass and treble).
11.
Press the CURSOR UP(▲)/DOWN(▼) buttons to
select the desired tone.
• Each time these buttons are pressed, the tone is
selected as follows :
→ BASS ↔ TRBL (treble) ↔ TONE: ON ←
12.
Press the CURSOR LEFT(◀)/RIGHT(▶) buttons to
adjust the selected tone as desired.
• The tone level can be adjusted within the range of -12 ~
+12 dB.
• In general, we recommend the bass and treble to be
adjusted to 0 dB (flat level).
• Extreme settings at high volume may damage your
speakers.
• To complete tone adjustment, repeat the above steps 11
and 12.
• If the tone display disappears, start from the step 9 again.