Sherwood RD-6504 Operating Instructions Manual page 21

RD-6504(G):RD-6504(G) 2009-02-12 오
Adjusting the current channel level
• After adjusting each channel level with test tone, adjust the channel levels either according to the program sources or to suit
your tastes.
• You can adjust the current channel levels as desired. These adjusted levels are just memorized into user's memory ("CAL"),
not into preset memory("REF 1", "REF 2").
1.
Press the CHANNEL LEVEL button.
2.
Select the desired channel.
3.
Adjust the level of the selected channel as desired.
4.
Repeat the above steps 2 and 3 to adjust each channel level.
9:35 페이지 21
All manuals and user guides at all-guides.com
or
or
• Then the memory mode ("REF 1", etc.) is displayed for
several seconds.
• When the memory mode or channel level disappears,
press this button again.
• Each time these buttons are pressed, the corresponding
channel is selected as follows:
→ REF 1, 2 (or CAL) ↔ FL ↔ C ↔ FR
→ <DTS or DD> ↔ SW ↔ SL ↔ SR
< >: Only when the digital signals from Dolby Digital or DTS
program sources that include LFE signal are input, LFE level
can be displayed.
• Depending on the speaker settings ("N (None or No)") and
surround mode, etc., some channels cannot be selected.
• When the SPEAKER button is set to off, only the Front
Left and Front Right channels can be selected.
• The LFE level can be adjusted within the range of -10~0
dB and other channel levels within the range of -15 ~ +15
dB.
• In general, we recommend the LFE level to be adjusted
to 0 dB. (However, the recommended LFE level for some
early DTS software is -10 dB.) If the recommended levels
seem too high, lower the setting as necessary.
21