Sherwood RD-6504 Operating Instructions Manual page 15

RD-6504(G):RD-6504(G) 2009-02-12 오
When CD, VIDEO 1~ 2 is selected as an input source
4.
Select the digital or the analog input connected as
desired.
• Each time this button is pressed, the corresponding input
is selected as follows:
→ o(ptical) → c(oaxial)1→ c(oaxial) 2 → H(HDMI audio)*
* : When VIDEO 1 or VIDEO 2 is selected, the HDMI audio
input can be selected.
■Notes :
• When AUX, F.AUX, TAPE, BT IN, EXT IN or tuner is
selected as an input source, the digital input cannot be
selected.
• When the selected digital input is not connected, the
"DIGITAL" indicator flickers and the analog input is
automatically selected.
• The selected digital or analog input is automatically
assigned to the corresponding input source on the INPUT
setup menu. (For details, refer to "SETTING THE INPUT "
on page 34.)
• The sound from the component connected to the selected
digital input can be heard regardless of the selected input
source.
5.
Operate the selected component for playback.
• When playing back the program sources with surround
sound, refer to "ENJOYING SURROUND SOUND" on
page 18.
6.
Adjust the (overall) volume.
U P
DO WN
9:35 페이지 15
All manuals and user guides at all-guides.com
or
A(nalog) ←
o r
7.
To mute the sound.
• "MUTE" will flicker.
• To resume the previous sound level, press it again.
8.
To listen with the headphones.
• Be sure to switch the speakers off.
• When listening to a DTS or Dolby Digital program source,
if the headphones are plugged in and the SPEAKER
button is set to off, it enters the 2CH downmix mode
automatically. (For details, refer to "2CH downmix mode"
on page 18.)
■Note :
• Be careful not to set the volume too high when using
headphones.
15