How To Sew On A Button - ELNA EnVision 8006 Instruction Manual

27
How to Sew on a Button
@ 4: Zigzag stitch
@® F: Satin stitch foot
@ Drop feed dog (see page 5)
Set the stitch width according to the position of the
holes in the button.
Match the holes in the button to the horizontal slot on
the presser foot.
Lower the foot to hold the button in place.
Turn the flywheel by hand until the needle is just
above the button.
Press the key to position the needle above the
left hole of the button.
Turn the flywheel to position the needle to enter the
right hole of the button. Readjust the stitch width if
necessary.
Stitch several times.
After you finish sewing, cut the thread but leave
10 to 15 cm (4" to 6") of thread at the button.
Pull the thread to the reverse side of the fabric and
tie the threads.
Raise the feed dog after sewing on buttons
(see page 5).