Straight Stitch Wo; Starting To Sew; Changing Sewing Direction; Finishing Off A Seam - ELNA EnVision 8006 Instruction Manual

Straight Stitch
Press the key. The machine will sew the straight
stitch in the center needle position.
The basic straight stitch is used for sewing seams,
zipper insertion, pintucks and rolled hems.
@ 1: Straight stitch
@® A: Metal foot
Starting to Sew
Raise the presser foot and position the fabric next to
a seam allowance line on the needle plate (see page
7). Lower the needle to the point where sewing is to
begin.
Pull the threads under the foot towards the back and
lower the presser foot. Press the foot control. Gently
guide the fabric along the seam allowance line letting
the fabric feed naturally.
Changing Sewing Direction
Stop the machine and bring the needle down into the
fabric by pressing the up/down needle key. Raise the
presser foot. Pivot the fabric around the needle to
change sewing direction. Lower the presser foot.
@ Up/down needle key
@ Presser foot lever
Finishing Off a Seam
To fasten the threads at the end of a seam, press and
hold the reverse key while sewing.
Raise the presser foot. Remove the fabric; pull the
threads to the back and cut threads using the thread
cutter. (The threads are cut the proper length to start
the next seam.)
©) Reverse key
© Thread cutter