Sony DCR-PC110 Operating Instructions Manual page 13

Step 1 Preparing the power supply
When you use your camcorder for a long time, we recommend that you power it fl'om a
wall outlet using tile AC power adaptor.
(1) Open the DC IN jack covet', pulling the cover out a little. Connect the AC
power adaptor supplied with your cmncorder to the DC IN jack on your
camcorder with the plug's • mark facing up.
(2) Connect the power cord to the AC power adaptor.
(3) Connect the power cord to a wall outlet.
2,3
PRECAUTION
The set is not disconnected from the AC power source (house current) as long as it is
connected to the wall outlet, even if the set itself has been turned off.
Notes
• The AC power adaptor can supply power even ifthe battery pack is attached to your
Call-leorder.
• The DC IN jack has "sotnce priority." This means that the battery pack cannot supply
any power if the power cord is connected to the DC IN jack, even when the power
cord is not plugged into a wall outlet.
Using a car battery
Use Sony DC Adaptor/Charger (not supplied).
13