Olivetti d-COLOR P3100 Manual page 70

4
Error messages
Message
[CONFIGURATION ERR]
[COVER OPEN]
[PAPER JAM]
[I-UNIT MISSING]
[TONER MISSING]
[WASTE TONER FULL]
[I-UNIT END]
[TONER OUT]
[PAPER MISMATCH]
[PAPER EMPTY]
[PAPER SIZE/TYPE MIS-
MATCH]
[INSUFFICIENT MEMORY]
[HOLD JOB ERROR]
[NO SPACE AVAILABLE ON
HDD]
[COUNTER LACK ERR]
[USB CONN ERR]
[JOB LOG ERROR]
Service call
If a service call has appeared, restart this machine.
If the problem is not resolved after this machine has been restarted, check the displayed trouble code num-
ber, then contact your service representative.
4-10
Description
The option configuration was
changed while the power was
turned on.
The cover is opened.
A paper jam has occurred.
The Imaging Unit is not installed
correctly.
The Toner Cartridge is not in-
stalled correctly.
The Waste Toner Bottle has be-
come full.
The operating life of the Imaging
Unit has expired.
Toner is depleted.
Paper of the specified size is not
loaded into a tray.
No paper is loaded in the tray.
The size and type of the paper
loaded in the tray specified from
the printer driver are different
from those of the paper loaded in
the tray on the main unit.
The size and type of the paper in
the tray that are specified on the
Control Panel do not match
those of the paper actually load-
ed in the tray.
Data has been received over the
maximum memory size.
The option configuration is dif-
ferent from that specified when a
job was saved.
The HDD capacity has become
full.
The accounting level has
reached "0" while executing a
job.
The same type of USB device is
connected.
The job log storage area on the
HDD is full.
Major messages and actions
Remedy
Restart this machine.
Close the cover.
Check a paper jam location, then re-
move the jammed paper.
Correctly install the Imaging Unit,
then close all doors.
Remove and install the Toner Car-
tridge, and close all doors.
Replace the Waste Toner Bottle.
For details, refer to page 2-15.
Replace the Imaging Unit.
For details, refer to page 2-9.
Replace the Toner Cartridge.
For details, refer to page 2-4.
Load the correct paper into the dis-
played tray.
Add paper to the tray, or change the
tray to make prints.
Load the paper of the appropriate
size and type into the tray, then
specify the correct size and type for
the loaded paper on the Control
Panel.
Load the paper of the appropriate
size and type into the tray, then
specify the correct size and type for
the loaded paper on the Control
Panel.
Cancel the job to reduce the amount
of data, then execute the job again.
Return to the option configuration
specified when a job was saved.
Delete data saved on the HDD, if
necessary.
Cancel the job.
Disconnect the USB device.
Delete job logs.
d-COLOR P3100
4.4