Table of Contents
Advertisement
DESCRIPTION OF PRODUCT
Parts description (Fig. A)
1. 5 in 1 nozzle
2. Lance
3. Battery pack waterproof housing
4. Battery pack release button
5. Water Inlet/ Hose Connector
6. ON/OFF Switch Trigger
7. Safety lock button
Check the delivery parts (Fig. B)
Remove the appliance from its packaging carefully and make sure that all of the
following parts are present:
a. AQUAJET2 housing
b. 5 in 1 nozzle
c. Hose
d. Water filter
e. Lance
f.
Battery pack
g. Charger
h. Foam sprayer
i.
Net bag
j.
Brush
k. Instruction manual and nozzle cleaning pin
l.
Foldable bucket
WARNING: If any parts are damaged or missing, do not operate this tool
until these parts have been replaced. Failure to heed this warning could
result in serious personal injury.
NOTE: Always recycle the packaging in accordance with local recycling
.
guidelines
22
INSTALLATION
Install the lance (Fig. C)
Align the lance to the main housing and push down firmly and then rotate the lance to secure
in place.
Fitting the 5 in 1 nozzle (Fig. D)
Align the 5 in 1 nozzle to lance and push down firmly and then rotate the lance to secure in
place.
OPERATION
Charging the battery pack
NOTE: Remove the battery pack from the charger after it has been fully charged.
NOTE: Battery should be fully charged before first use.
NOTE: Make sure the mains voltage is the same as rating label which is located on the
charger.
1.
Connect the charger to a power supply. Red LED will light up.
2.
To insert the battery pack into the charger, align the raised ribs of the battery pack with
the grooves of the charger then push it in. (Fig. E)
3.
The red LED light of the charger will light up and then the green light flashes during
normal charging.
4.
After charging is complete, the charger light will turn to a solid green light.
5.
Once the battery is fully charged, depress the battery release button and then remove
the battery pack. (Fig. E)
Power indicator (Fig. F)
This Li-Ion battery pack is equipped with a power indicator which is used to show the battery
pack's remaining charge. Press the power indicator button to check battery charge as picture
showed. The indicator will stay lit for approximately 4 seconds.
To obtain the best life from the battery
1.
Never allow the battery to completely discharge before recharging. The battery pack
should be placed on the charger whenever the battery pack is noticeably running down
or the tool no longer performs a task it previously performed.
2.
Avoid conducting short charges. Make sure that the battery is fully charged each time by
allowing the charger to complete its full charging cycle.
3.
Avoid allowing loose items like screws or nails etc. to be stored with battery packs as
these or similar items can short battery packs and cause a fire or explosion.
4.
Always unplug the charger when not in use and store in a dry and secure place.
5.
Avoid charging or storing your battery in temperatures below 5°C and above 45°C.
6.
After use, allow the battery pack to cool down for approximately 30 minutes before
attempting to recharge.
23
Advertisement
Table of Contents
