National Instruments NI ELVIS III Getting Started page 12

Note
the wireless network.
2. Configure a wireless network on the NI ELVIS III.
Configuring a Wireless Network on the Device
Note
NI ELVIS III automatically connects to the wireless network that it has
connected to before.
1. Use a USB cable to connect the NI ELVIS III to your computer, as explained in
Connecting to the Device via
2. In Internet Explorer, enter http://<USB IP address>/WIF.html in the address
bar to launch the System Configuration page. To view the IP address of the
USB connection, press and hold the user programmable button (Button 0) on
the left-hand side of the NI ELVIS III workstation until the OLED display on the
workstation is lit. The IP address of the USB connection appears after the
icon.
12
ni.com
The USB cable is also required for the initial configuration of
The following steps are required for initial configuration only. The
USB.
NI ELVIS III Getting Started