McCulloch 967059700 Operator's Manual page 35

Message Cause
Stuck in charging
There is an object in the way of the
station
product preventing it from leaving the
charging station.
Upside down
The product is leaning too much or has
turned over.
Needs manual
The product is set in the
charging ing mode.
Next start hh:mm
The timer setting prevents the product
from operating.
The rest period is in progress. The
product has an inbuilt standby period
according to the Standby time table.
The day's mowing
The rest period is in progress. The
is complete
product has an inbuilt standby period
according to the Standby time table.
Lifted
The lift sensor has been activated as
the product has become trapped.
Collision sensor
Product body can not move freely
problem, front/rear
around its chassis.
Wheel drive prob-
Grass or other object is wrapped
lem, right/left around the drive wheel.
Alarm! Mower
The alarm was activated because the
switched off
product was switched OFF.
Alarm! Mower
The alarm was activated because the
stopped
product was stopped.
Alarm! Mower lif-
The alarm was activated because the
ted
product was lifted.
Alarm! Mower til-
The alarm was activated because the
ted
product was tilted.
Temporary battery Temporary battery or firmware related
problem
issue in the product.
Charging current
Wrong or faulty power supply unit.
too high
1054 - 001 -
Action
Remove the object.
Turn the product the right way up.
MAN operat-
Place the product in the charging sta-
tion. This behavior is normal and no ac-
tion is required.
Change the timer settings. Refer to
do the timer settings on page 22 .
This behavior is normal and no action
is required. Refer to
on page 28 .
This behavior is normal and no action
is required. Refer to
28 .
Free the product.
Check that the product body can move
freely around its chassis.
Clean the wheels and around the
wheels.
Adjust the product security level in the
Security menu.
Restart the product. Disconnect and re-
connect the battery.
The message may require action by
authorized service technician.
To
Timer and Standby
Standby on page
Troubleshooting - 35