Table of Contents
Advertisement
3.9.5.1 ECO mode
ECO mode stops the signal in the boundary loop,
the guide wire and the charging station, when the
product is parked or is charging.
ECO mode to save energy and avoid
Note: Use
interference with other equipment, for example
hearing loops or garage doors.
Note: Push the STOP button before you remove
the product from the charging station. If not, the
product can not be started in the work area.
To set the ECO mode
To get access to the menu
1.
Do steps 1–3 in
on page 22 .
2.
Use the multi-choice buttons to move
through the menu structure
mode .
OK .
3.
Push
3.9.5.2 To set the Time & Date
1.
Do steps 1–3 in
To get access to the menu
on page 22 .
2.
Use the multi-choice buttons to move
through the menu structure
& Date .
3.
Use the number buttons to set the time and
OK .
then push
4.
Use the number buttons to set the date and
OK .
then push
5.
Use the multi-choice buttons to set the time
format and then push
6.
Use the multi-choice buttons to set the date
format and then push
3.9.5.3 To set the language
To get access to the menu
1.
Do steps 1–3 in
on page 22 .
2.
Use the multi-choice buttons to move
through the menu structure
Language.
3.
Use the multi-choice buttons to select
language and then push
3.9.5.4 To set the country
To get access to the menu
1.
Do steps 1–3 in
on page 22 .
1054 - 001 -
Settings > ECO
Settings > Time
OK .
OK .
Settings >
OK .
2.
Use the multi-choice buttons to move
through the menu structure
Country.
3.
Use the multi-choice buttons to select
country and then push
3.9.5.5 To set the Remote start function (ROB
R600)
To get access to the menu
1.
Do steps 1–3 in
on page 22 .
2.
Use the multi-choice buttons to move
through the menu structure to select
Installation > Remote start > Proportion .
3.
Select how often the
shall be used. There are 5 options:
•
Never (0%)
•
Rarely (approx. 20%)
•
Medium (approx. 50%)
•
Often (approx. 80%)
•
Always (100%)
OK .
4.
Push
3.9.5.6 To set the Calibrate guide function (ROB
R600)
Calibrate guide function allows you to test if
The
the product can follow the guide wire out from the
charging station.
1.
Place the product in the charging station.
To get access to the menu
2.
Do steps 1–3 in
on page 22 .
3.
Use the multi-choice buttons to move
through the menu structure
Calibrate guide and push OK .
The product will leave the charging station,
run a calibration process in front of the
charging station and then follow the guide
wire to the connection point with the
boundary wire and then start mowing
4.
Check that the product can follow the guide
wire all the way to the connection point with
the boundary wire.
Settings >
OK .
Remote start function
Settings >
Installation - 25
Advertisement
Table of Contents
