Troubleshooting; Introduction - Troubleshooting; Messages - McCulloch 967059700 Operator's Manual

6.1 Introduction - troubleshooting

In this chapter, a number of messages are listed which may be shown in the display if there is a
malfunction. There is a proposal as to the cause and steps to take for each message. This chapter also
presents some symptoms that can guide you if the product does not work as expected. More
suggestions for steps to take in the event of malfunction or symptoms can be found on
www.mcculloch.com.

6.2 Messages

Below a number of messages are listed which may be shown in the display of the product. Contact
your local McCULLOCH representative if the same message appears often.
Message Cause
Wheel motor
Grass or other object is wrapped
blocked, left/right
around the drive wheel.
Cutting system
Grass or other object is wrapped
blocked
around the blade disc.
The blade disc lies in a pool of water.
Trapped
The product has got caught in some-
thing.
The product is stuck behind a number
of obstacles.
Outside working
The boundary wire connections to the
area charging station are crossed.
The boundary wire is too close to the
edge of the work area.
The work area slopes too much.
The boundary wire is laid in the wrong
direction around an island.
Disturbances from metal objects (fen-
ces, reinforcement steel) or buried ca-
bles close by.
The product finds it hard to distinguish
the signal from another product installa-
tion close by.
1054 - 001 -

6 Troubleshooting

Action
Check the drive wheel and remove the
grass or other object.
Check the drive wheel and remove the
grass or other object.
Move the product and prevent the col-
lection of water in the work area.
Free the product and rectify the reason
for it becoming trapped.
Check if there are any obstacles which
make it hard for the product to move on
from this location.
Check that the boundary wire is con-
nected correctly.
Check that the boundary wire has been
laid according to the instructions in
install the boundary wire on page 20 .
Try moving the boundary wire.
Place the product in the charging sta-
tion and generate a new loop signal.
Refer to
on page 24 .
To create a New loop signal
Troubleshooting - 33
To