McCulloch 967059700 Operator's Manual page 34

Message Cause
Low battery / Emp-
The product cannot find the charging
ty battery
station.
The guide wire is broken or not connec-
ted.
The battery is spent.
The charging station's antenna is de-
fective.
Wrong PIN
Wrong PIN code has been entered.
Five attempts are permitted, and the
keypad is then blocked for five minutes.
Wheel motor over-
The product has got caught in some-
loaded, right/left
thing.
No drive
The product has got caught in some-
thing.
The work area includes a steep slope.
The guide wire is not laid at an angle
on a slope.
Charging station
The contact between the charging
blocked strips and contact strips may be poor
and the product has made a number of
attempts to charge.
An object is obstructing the product.
The charging station is tilted or bent.
34 - Troubleshooting
Action
Check that the charging station and the
guide wire are installed in accordance
Installation of
with the instructions in
the product on page 19 .
Check that the indicator lamp in the
charging station flashes yellow. Refer
Indicator lamp in the charging station
to
on page 37 .
Replace the battery. Refer to
place the battery on page 32 .
Check if the indicator lamp in the
charging station flashes red. Refer to
Indicator lamp in the charging station
on page 37 .
Enter the correct PIN code. Contact
your local McCULLOCH representative
if you forget the PIN code.
Free the product and rectify the reason
for the lack of drive. If it is due to wet
grass, wait until the lawn has dried be-
fore using the product.
Free the product and rectify the reason
for the lack of drive. If it is due to wet
grass, wait until the lawn has dried be-
fore using the product.
Maximum guaranteed slope is 25%.
Steeper slopes should be isolated. Re-
To put the boundary wire in a
fer to
slope on page 17 .
If the guide wire is laid on a slope, it
must be laid at an angle across the
To examine where to
slope. Refer to
put the guide wire on page 18
Put the product in the charging station
and check that the charging strips and
contact strips make good contact.
Remove the object.
Confirm that the charging station is
placed on a fully flat and horizontal
ground. The charging station must not
be tilted or bent.
To re-
1054 - 001 -