Table of Contents
Advertisement
0 cm / 0"
CAUTION: Do not put a section of
boundary wire across the other.
The sections of boundary wire
must be parallel.
CAUTION: Do not put the guide
wire across the boundary wire, for
example a boundary wire that
goes to an island.
3.3.3.4 To make a secondary area
Make a secondary area (B) if the work area has 2
areas that are not connected with a passage. The
work area with the charging station is the main
area (A).
Note: The product must be manually moved
between the main area and the secondary area.
18 - Installation
B
A
•
Put the boundary wire around the secondary
area (B) to make an island. Refer to
make an island on page 17 .
Note: The boundary wire must be put as 1
loop around all of the work area (A + B).
Note: When the product cuts grass in the
secondary area, the
To make an island on
selected. Refer to
page 17 .
3.3.4 To examine where to put the guide
wire
•
Put the guide wire in a line at a minimum of
2 m / 7 ft. in front of the charging station.
•
Make sure that the guide wire has as much
free area as possible to the left of the guide
wire when facing the charging station. Refer
Guide calibration on page 21 .
to
•
Put the guide wire minimum 30 cm / 12 in.
from the boundary wire.
•
Do not make sharp bends when you install
the guide wire.
•
If the work area has a slope, put the guide
wire diagonally across the slope.
To
MAN mode must be
1054 - 001 -
Advertisement
Table of Contents
